Gree GKH12K3BI, Service Manual

Page: 41 / 209

38
U-MATCH Air
Conditioners
Service Manual
DPOUSPM
4.3 Dimension
Outline dimension
85
85
60
85
85
21.2
85
42.5
Installation dimension
4.4 Installation
1. First select an installation position. According to the size of the communication line of the wire controller,
leave a recess or a embedded wire hole to bury the communication line.
2. If the communication line between the wire controller (85×85×20) and the indoor unit is surface-mounted, use
1# PVC pipe and make matching recess in the wall (refer to Figure 6); If concealed installation is adopted, 1#
PVC pipe can be used (Refer to Figure 7).
3. No matter if surface mounting or concealed mounting is selected, it is required to drill 2 holes (in the same
level) which distance shall be the same as the distance (60mm) of installation holes in the bottom plate of the
wire controller. Then insert a wood plug into each hole. Fix the bottom plate of the wire controller to the wall
by using the two holes. Plug the communication line onto the control panel. Lastly install the panel of the wire
controller.
Caution:
During the installation of the bottom plate of the wire controller, pay attention to the direction of the bottom plate.
The plate’s side with two notches must be at the lower position, and otherwise the panel of the wire controller
cannot be correctly installed.
Aipe
Fig6:Surface Mounting of Cable Fig7:Concealed mounting of Cable