Gree CF01000730, Service Manual

Page: 58 / 129

GREE Duct type split Air conditioner Inverter Series
56
2.1 Refrigerant piping
(1) Material requirement: Dephosphorization drawing copper pipe for air conditioners.
(2) Appearance requirement: The inner and outer surface of pipe should be smooth without pinhole,
crack, peeling, blister, inclusion, copper powder, carbon deposition, rust, dirt or severe oxide film,
and without obvious scratch, pit, spot and other defects.
(3) Test report: Certifications and quality test reports must be provided.
(4) The tensile strength must be at least 240 kgf/mm².
(5) Specifications requirement.
R410A Refrigerant System
OD (mm/inch) Wall Thickness (mm) Model
Ф6.35(1/4) ≥ 0.8 0
Ф9.52(3/8) ≥ 0.8 0
Ф12.70(1/2) ≥ 0.8 0
Ф15.9(5/8) ≥ 1.0 0
Ф19.05(3/4) ≥ 1.0 0
Ф22.20(7/8) ≥ 1.2 0
Ф25.40(8/8) ≥ 1.2 0
(6) After the inner part of the copper pipe is cleaned and dried, the inlet and outlet must be sealed
tightly by using pipe caps, plugs or adhesive tapes.
2.2 Condensate water pipe
(1) Pipes that can be used for air conditioner drainage include: water supplying UPVC pipe, PP-R
pipe, PP-C pipe, and HDG steel pipe.
(2) All relevant certificates and quality test reports are provided.
(3) Requirements for specifications and wall thickness.
Water supplying UPVC pipe: Φ32 mm×2mm
，
Φ40 mm×2mm
，
Φ50 mm×2.5mm.
HDG steel pipe: Φ25 mm×3.25mm
，
Φ32 mm×3.25mm
，
Φ40 mm×3.5mm
，
Φ50 mm×3.5mm.
2.3 Insulation material
(1) Rubber foam insulation material.
(2) Flame retardancy level: B1 or higher.
(3) Refractoriness: at least 120°C.
(4) The insulation thickness of condensate water pipe: at least 10 mm.
(5) When the diameter of copper pipe is equal to or greater than
Φ15.9 mm, the thickness of
insulation material should be at least 20 mm; when the diameter of copper pipe is less than 15.9
mm, the thickness of insulation material should be at least 15 mm.