27
❏
12. Connect the aileron and fl ap servo leads to the dual
servo extensions.
❏
13. Fit the plywood wing root tabs into the slot in the fuselage.
❏
14. Use the included 1/4-20 nylon wing bolts to secure the
wing in place. The tool shown in the picture is a Great Planes
4-In-1 Installation Tool (GPMR8035 not included).
❏
15. You are now completed with the assembly of your Avistar
Elite. Charge your batteries if you have not already done so
and complete the fi nal setup of your model.
Apply the Decals
❏
1. Use scissors or a sharp hobby knife to cut the decals
from the sheet.
❏
2. Be certain the model is clean and free from oily fi ngerprints
and dust. Prepare a dishpan or small bucket with a mixture
of liquid dish soap and warm water—about one teaspoon of
soap per gallon of water. Submerse the decal in the soap and
water and peel off the paper backing.
Note:
Even though the
decals have a “sticky-back” and are not the water transfer type,
submersing them in soap & water allows accurate positioning
and reduces air bubbles underneath.
❏
3. Position decal on the model where desired. Holding the
decal down, use a paper towel to wipe most of the water away.
❏
4. Use a piece of soft balsa or something similar to squeegee
remaining water from under the decal. Apply the rest of the
decals the same way.
