NOTICE TECHNIQUE LS100
LS100 TECHNICAL MANUAL
Date : June 2009 From
Aftersales Technical Support
Ref. LS100 GB/FF - Vers. 1.0
Page 38
Unscrew a coupling screw, then move the bridge to adjust the angular.
Only the shaft must move, the stepper motor shaft must not move
Desserrer une vis de coupling Y, puis bouger le pont pour l’ajuster. Seul
l’axe un axe doit bouger quand le pont bouge, l’axe moteur ne doit pas
bouger
Make a new squareness checking by moving the set square to
the left and right side of the X Bridge.
Faire un nouveau contrôle d’équerrage en déplaçant l’équerre
à droite et à gauche du pont X.
Put back the back plaque by 2 screws.
Replacer la plaque de fond du laser par 2 vis.
Put back the left and right casings .
Replacer les carters gauche et droit .
Put back the top cover = see chapter LS100-02
Replacer la porte supérieure= voir chapitre LS100-02
This operation is finished, make an engraving test.
Opération terminée, procéder à un essai de gravure.