Page 8
This model is an pneumatic automatic model, high pressure, high efficiency and good
return rate.
Check the voltage before using the device. The correct voltage is 220-240V/50Hz. Do
not set the temperature higher than 235°C. The operating temperature ranges
between 0°C and 235°C. You can set the temperature in degrees Celsius.
Insert the power plug into the unit. Insert the power plug into the power outlet. Turn
the press on at the on/off switch. The control panel will now light up.
Commissioning
GRAVEDA®
GRASPRESSO®
Registered Trade Mark Registered Trade Mark
1.
Make sure that the power plug is well connected to the outlet, then press the
power button to turn on the unit.
2.
connect the air compressor, adjust the air regulator to 0.4-0.6 MPa (pull the cap
of The regulator up before adjustment, push the cap down when adjustment is
complete).
We do not accept any liability for damage or injury to you or third
parties caused by incorrect use or connection of the press to your existing air
compressors. We do not accept liability for damage to you or third parties
caused by improper or incorrect or intentional misuse of the press.
3.
Set the temperature and time as desired
4.
when the temperature has reached the previously set temperature the device
beeps
5.
Press the start button. The press closes automatically and starts the process.
6.
The beep sounds again when the set time has elapsed, the plates are opened
automatically.
7.
If an emergency situation occurs, press the emergency button, the plates are
lifted immediately and the machine switches off.
8.
The press has an integrated fan. The fan starts automatically when the
temperature of the heating plate reaches 80 °C (176 °F). It helps to reduce the
temperature of the electrical parts and prolong the life of the press.
