GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Keine Haftung für Druckfehler. Technische Änderungen vorbehalten!
#0059939
04/2008
18
•
When the glue has hardened fully, turn the boat over and reinforce the
joint between the top shell and the bottom section from the inside by allowing adhesive to run along the
channel above the horizontal crutch.
•
Continue the two 7 mm Ø holes through the transom reinforcement (part 3).
•
Sharpening the edges of the hull
steps increases the boat’s top speed
and stability, and this can be
achieved by gluing the planing
panels (parts 15) to the underside of
the hull using cyano.
•
Fitting the panels inevitably
produces gaps along the sides, and
these can be filled with filler paste if
you wish; it is not essential to do
this.
•
Now assemble the boatstand from
the laser-cut 4 mm plywood parts,
as shown in the drawing.
•
Apply several coats of Glattfix
(cellulose lacquer, Order No. 207) to
the stand to render it waterproof.
•
Slit the two pieces of silicone tubing (parts 14)
along their length and glue them to the support
surfaces of the boatstand using contact cement
(Order No. 1096); this avoids scratching the
boat’s surface.
•
Allow the boatstand to dry out thoroughly before
placing the boat in it.
2. Next glue this area with Stabilit Express
Drill out to 7 mm Ø
3. Apply thick cyano or UHU-Plast Spezial here,
then fill any gaps with more adhesive
Important
Do not use tape!
15
12
14
14
12
10
13
11
