GRASS VALLEY Profile XP PVS1100, Installation Manual

Page: 23 / 42

Set up PFR500 network settings
18 September 2002 PVS 1100 Series Installation Guide
23
Press Enter to accept defaults.
APPLICATION PARAMETERS:
Boot Choices: [1]Factory Flash Loader or [2]Ciprico Network Server
Your Choice (1 or 2)? [2]
Press Enter to accept defaults.
[NOTE: The default value
may appear different than
shown here.]
Mail and SNMP notification level: 1 (most verbose) through 5 (off)?
[2]
Press Enter. Modify User Password? [N]
Type
y
, then press Enter. Modify SNMP Trap Information? [N]
Type
public
, then press
Enter.
Trap Community Name? [ ]
Type the Profile XP IP
address, then press Enter. Add
additional trap destinations, if
needed (up to four total), or
press Enter a number of times
to advance to the next step—
Modify SNMP MIB
Communities.
NOTE: You can enter the
factory default IP address
for your Profile XP system
(192.168.0.10) unless you are
modifying it for an existing
network.
You may enter up to 4 Hosts to receive Traps sent by this device
Enter Trap Manager #1 IP Address? [0.0.0.0]
Enter Trap Manager #2 IP Address? [0.0.0.0]
Enter Trap Manager #3 IP Address? [0.0.0.0]
Enter Trap Manager #4 IP Address? [0.0.0.0]
Press Enter. Modify SNMP MIB Communities? [N]
Press Enter. Modify Mail parameters? [N]
Press Enter to accept defaults.
NOTE: Default value may
appear different than shown
here.
How long (in seconds) should CPU delay before starting up? [10]
PFR 500 configuration is
displayed showing your
settings. NETWORK INTERFACE PARAMETERS:
IP address on LAN is 192.168.0.11
LAN interface's subnet mask is 255.255.255.0
COMMUNICATION PARAMETERS:
Serial channels will use a baud rate of 9600
HARDWARE PARAMETERS:
This board's MAC Address is 0:20:46:11:14:23
APPLICATION PARAMETERS:
Boot Ciprico Network Server
Mail and SNMP notification will occur for Hardware changes,
Warnings, and Critical events.
SNMP TRAP CONFIGURATION:
TRAP COMMUNITY NAME 'public'
TRAP MANAGER #1 IP Address 192.168.0.10
After board is reset, start-up code will wait 10 seconds
Instructions Text entered and displayed in terminal window
y
public
192.168.0.10