GRASS VALLEY Profile XP PVS1100, Installation Manual

Page: 22 / 42

Set up PFR500 network settings
22
PVS1100 Series Installation Guide 18 September 2002
The boot screen appears. After
default settings are displayed,
press any key within 10 sec,
otherwise, the PFR500 will
initialize and display a
command prompt.
NOTE: If you miss the 10
second window, type
reboot again when the
command prompt appears,
then press Enter, or try
cycling the power on the
PFR500 RAID Controller
chassis. You can leave the
PFR500E Expansion chassis
on. The boot screen should
appear.
Rebooting now - this will kill this shell.
Ciprico Web Manager
Copyright Ciprico Inc. 2000
--------------------------------------------------------------------------
NETWORK INTERFACE PARAMETERS:
IP address on LAN is 192.168.0.11
LAN interface’s subnet mask is 255.255.255.0
COMMUNICATION PARAMETERS:
Serial channels will use a baud rate of 9600
HARDWARE PARAMETERS:
This board’s MAC Address is 0:20:46:11:14:23
APPLICATION PARAMETERS:
Boot Ciprico Network Server
Mail and SNMP notification will occur for Hardware changes,
Warnings, and Critical events.
SNMP TRAP CONFIGURATION:
TRAP COMMUNITY NAME ’public’
TRAP MANAGER #1 IP Address 192.168.0.10
After board is reset, start-up code will wait 10 seconds
--------------------------------------------------------------------------
To change any of this, press any key within 10 seconds.
Press Enter to modify
settings. (M)odify any of this or (C)ontinue? [M]
Press Enter to configure a
LAN interface.
For each of the following questions, you can press <Return> to select
the value shown in braces, or you can enter a new value.
NETWORK INTERFACE PARAMETERS:
Do you want a LAN interface? [Y]
Type the IP address for this
RAID Controller, then press
Enter.
NOTE: RAID Controller A
and the optional RAID
Controller B must use
different IP addresses. Also,
the subnet must match the
Profile XP subnet unless a
gateway is used.
IP address(0.0.0.0 = RARP, 255.255.255.255 = DHCP/BOOTP)?
[192.168.0.11]
Type the subnet mask value,
then press Enter. Subnet mask for LAN (0 for none)? [255.255.255.0]
If a gateway is used, type
y
,
then press Enter, to provide a
Gateway address, otherwise,
just press Enter to continue.
Should there be a default gateway for packet routing? [N]
Press Enter to accept defaults.
COMMUNICATION PARAMETERS:
Baud rate for serial channels [9600]
Instructions Text entered and displayed in terminal window
<enter your IP address>
255.255.255.0