GRASS VALLEY LDK 4000 ELITE -, User Manual

Page: 29 / 122

LDK 8000 Elite/4000 Elite System camera User’s Guide (v1.01) 29
Chapter 2 - Installation
To attach the adaptor to the camera head proceed as follows:
1. Fit the guide pin at the top rear of the camera head and the guide pins on either side of
the camera connector into the corresponding slots (1 and 2) of the adaptor.
2. First, tighten the two horizontal screws (3) on the top of the camera head.
3. Next, tighten the two horizontal screws (4) at the front of the camera head.
4. Lastly, tighten the vertical screw (5) in the handgrip of the camera head.
2.8 LDK 5020/05 Universal transport case
Both your camera and its accessories are sensitive equipment, so it is important to protect
these against damage when transporting it. To do this, a universal transport case is optionally
available for the camera, lens, viewfinder and some accessories.
Figure 2-10. Universal transport case
The camera is packed in the case as shown in the figure above. This ensures that the camera is
not damaged during transport. Turn the LDK5302/60 2-inch viewfinder downwards so that it
does not protrude above the top of the camera.
Several foam packing inserts are provided to enable different configurations of the camera to
be packed securely. These inserts are used to support the rear of the camera. Make sure you
use the correct foam inserts for your particular configuration.
Caution
To prevent damage always detach the lens from the camera head before transporting.
user’s guide
packing inserts
top light
tripod plate
power
supply unit
additional
supplies