18
Setting Up Your Kaleido-MX Multiviewer
Networking Setup
13 Press ESC to return to the previous level in the local control menu.
LINK MODE EDIT appears again on the LCD display.
14 Press the [–] button.
OUTPUT A IP EDIT appears on the control panel’s display.
15 Repeat
step 3
and
step 4
to configure the IP address for Output A.
16 Once you have set the IP address for Output A, and navigated back to the previous
menu level, press the [–] button again.
OUTPUT B IP EDIT appears on the control panel’s display.
17 Repeat
step 3
and
step 4
to configure the IP address for Output B.
18 Once you have set the IP address for Output B, press the Select button
on the front edge
of the output card
to exit the control menu.
After a moment, both output cards restart. The startup sequence takes approximately
four minutes, during which time the cards’ Status LEDs are first red and then blinking
orange.
19 Once the startup has completed, check both cards’ Status LEDs again, and make sure
that they do not indicate an error condition.
Should a Status LED indicate an error condition, refer to your Kaleido-MX (1RU)
Hardware Description & Installation Manual to find out what the other LEDs might be
indicating.
20 Verify that both cards’ and the system’s new IP addresses are effective, by referring to
Verifying the Multiviewer’s IP Addresses and Application Version
, on page 34.
Setting the System Name
Once you have configured the output cards from the local control panel, use XAdmin to
complete your system’s network setup.
Notes
• If you do not press any button on the Densité frame local control panel, the
Densité controller will revert to its normal standby mode, and the selected
card's Status LED will revert to its normal operating mode, after 30
seconds.
• If you changed a parameter from the card’s control menu, but have not
applied your change (you did not press the SEL button on the local control
panel), once the 30-second timeout has occurred, the parameters will be
confirmed as if you had pressed the SEL button.
Green
Normal
Blinking orange Booting (or the card is selected for local control)
Red
Firmware initialization in progress / no Ethernet / SD card error
Blinking red
Fan failure / no rear / duplicate IP address
Summary of Contents for KALEIDO-MX
Page 48: ......
