GRASS VALLEY Ignite HDC Series, Instruction Manual, Page: 66 / 122

66 Ignite SDC/HDC Robotic Camera Instruction Manual
Appendix B — SD (PAL) Camera Block
Color Setting
Figure 37. Color Setting Submenu
G/L Adjustment Setting
Figure 38. G/L Adjustment Setting Submenu
Table 20. Color Settings
Selection Description
Chroma Level
(-3 to +3) Chroma Level can be decreased or increased to any of three lev-
els each.
Flesh Tone
(-3 to +3) Skin color can be decreased or increased to any of three levels
each.
White Bal
ATW: The white balance is automatically adjusted to be always right.
AWC A, AWC B: Once the white balance is adjusted with the ITEM/AWC
switch on the back of the camera, it is no longer necessary to set the white
balance again if you simply select AWC A or AWC B, provided that the
camera is used under the same conditions. Fine color adjustment can be
made after setting AWC by red/blue gain adjustment in user mode.
3200 K: The white balance is adjusted to 3200 K illumination.
5600 K: The white balance is adjusted to 5600 K illumination.
ATW Speed (Slow 2, Slow 1, Mid, Fast 1, Fast 2) ATW speed can be set.
Table 21. G/L Adjustment Settings
Selection Description
H Phase
(-206 to +49) Horizontal phase can be adjusted when a genlock signal is
supplied.
SC Coarse
(1, 2, 3, 4) Coarse adjustment of sub carrier phase can be made when a
genlock signal is supplied.
SC Fine
(-511 to +511) Fine adjustment of sub carrier phase can be made when a
genlock signal is supplied.
8492_29_r0
8492_30_r0