GRASS VALLEY Ignite HDC Series, Instruction Manual

Page: 24 / 122

24 Ignite SDC/HDC Robotic Camera Instruction Manual
Section 2 — Installation
Robotic Pan/Tilt Head Assembly
Note Ignite SDC/HDC robotic cameras are suitable for inverted mounting.
1. Check the selected camera location to ensure that there is enough
clearance (
Figure 5 ) for the fully assembled camera, prompter, and
cables to pan and tilt without obstruction.
If necessary, you can limit pan and/or tilt movement by adjusting the
pan/tilt head soft stops via the SHOT Director controller. Refer to the
JSC-2300 SHOT Director Robotics/Camera Controller Instruction
Manual.
Figure 5. Clearance Diagram
2. On the stationary ring at the top of the pedestal mount ( Figure 6 ), locate
the zero-degree (pan) position labeled FRONT. Point the FRONT label
in the direction that best reflects the center of travel in which the camera
will be used (usually the center of the room).
Figure 6. Robotic Pan/Tilt Head Assembly
Diameter: 24” (0.61 m)
48” (1.22 m) with prompter
8492_06_r0
Camera mount
L-bracket
Robotic
pan/tilt
head
8” Pedestal
mount
Zero degree
(Pan)
reference
Front
8
492_05_r0