8900NET—Instruction Manual
59
Using the 8900NET GUI
When the SNMP Agent is successfully installed, the Configuration web
page will contain the additional items listed below and shown in
.
•
SNMP Trap Reports Link
– when the SNMP Agent is installed an SNMP
Trap Reports link will be present on the Configuration web page (and
other web pages) to link to the SNMP Reporting web page (
).
The following SNMP trap reports are provided for the 8900NET
module:
•
Net Card Status (Alarm)
•
Hardware Switch (Informational)
•
SNMP Report Activation Modes
– each report destination has an activation
control that can select one of the following modes of operation:
•
CREATE – GO
creates a new report destination that becomes active
after the next module reboot.
•
CREATE – WAIT
creates a new report destination that remains out of
service until the user selects active and then reboots the module.
•
ACTIVE
changes a
NOT IN SERVICE
report destination to active after the
next module reboot.
•
NOT IN SERVICE
changes an active report destination to inactive after
the next module reboot.
•
DELETE
removes the report destination entry. If the entry was active
it remains active until the next module reboot.
Note
Report destination status does not change until the 8900NET module is
rebooted.
The status column to the left of the activation operation pull-down
window provides one of the following status reports:
•
<BLANK> –
No entry has been applied.
•
ACTIVE
– All new status reports will be sent to this destination.
•
NOT IN SERVICE
– The destination has a valid definition but the user
has not activated it.
•
ACTIVE PENDING REBOOT –
This entry indicates the report destination
will become active upon the next module reboot.
•
NOT IN SERVICE PENDING REBOOT
– This entry indicates the report des-
tination will become inactive upon the next module reboot.
•
NOT READY
– The destination entry is invalid. The IP Address may
not be properly defined or there is no IP Address or Community
entry.
Summary of Contents for 8900NET -
Page 6: ...6 8900NET Instruction Manual Preface ...
Page 49: ...8900NET Instruction Manual 49 Using the 8900NET GUI Figure 25 LED Reporting Web Page ...
Page 51: ...8900NET Instruction Manual 51 Using the 8900NET GUI Figure 26 SNMP Reporting Web Page ...
Page 82: ...82 8900NET Instruction Manual Specifications ...