GRASS VALLEY 8900NET -, Instruction Manual

Page: 20 / 106

20 8900NET—Instruction Manual
Power Up
Power Up
The various front LED indicators and configuration switches on the
8900NET module are illustrated in
Figure 12 . Upon power-up, all LEDs
should light for the duration of the initialization process. The frame is
powered up when either of the AC mains connections are made on the rear
of the frame (
Figure 6 on page 14 for Gecko frame and Figure 7 on page 14
for GeckoFlex frame).
After initialization the Power LED will be on and the red Network Module
LED (labeled NM) should be off. All other LEDs report detected fault con-
ditions within the frame and the installed modules. If the NM LED does not
go off, the board needs servicing.
Note When a media module is first plugged into an 8900 frame, the 8900NET
module may report a momentary fault. This will clear once the media module
has booted up.
Figure 12. LEDs and Configuration Switches on the 8900NET Module
LEDs on the 8900NET module primarily indicate status items from the
frame and the modules in the frame. Some functions specific to the
8900NET module are also reported (PWR, ETHER, COMM). LED reporting
for each specific LED on the front of the 8900NET module can be disabled
if desired on the LED Reporting web page (
LED Reporting Web Page on
page 48 ).
Table 2 on page 21 describes all the module’s LEDs and the conditions indi-
cated.
FAN ( r ed)
MOD - Mod u le Health B us ( r ed)
PS1 - Powe r S u pply 1 ( r ed)
PS2 - Powe r S u pply 2 ( r ed)
TEMP - Tempe r at ur e ( r ed)
S1
8
7
6
5
4
3
2
1
8
7
6
5
4
3
2
1
PWR - Powe r (g r ee n )
Red = Fa u lt
G r ee n = OK
Yellow = Active
LED Colo r Key
NM - Netwo r k I n te r face Mod u le ( r ed)
FB - F r ame B us ( r ed)
COMM - Comm un icatio n (yellow)
ETHER - Ethe rn et comm un ictio n
(yellow)
REM OVR - Remote Ove rr ide
(yellow)
FAULT - F r ame Fa u lt ( r ed)
INHIB - Mod u le Health I n hibited
(yellow)
Co n fig ur atio n DIP s witch S1
0612 -06
r
1
Co n fig ur atio n DIP s witch S2