8 – 4
8.2 Specifying the Special Functions
Step
3
Press the
F1/ORIGIN
or
F2/TEST
key to move the flashing cursor to the desired setting.
At the PARALLEL I/F menu, use the
or
key to raise or lower the value.
When the desired setting is selected, press the
ENTER
key to register your setting.
At this time, if you press the
NEXT PAGE
key without pressing the
ENTER
key, the cutting plotter displays
the next special function menu without registering the setting you selected at the current menu.
Step
4
When all of the special functions have been satisfactorily set, turn off the cutting plotter.
Step
1
While holding down the
key, turn on the cutting
plotter. The menus for setting the special functions
will appear at the display panel.
Step
2
Depending on the current COMMAND setting (GP-
GL or HP-GL), press the
NEXT PAGE
key to cycle through
the special function menus in the sequence shown
below.
In HP-GL command mode
7550 MODEL
7586 EMULATED
MANUAL SETTING
COMD PRIORITY
2mm BELOW INIT
OUTSIDE BLADE
ENABLE PEN UP
DISABLE MOVE
OFF MEDIA
ON SENSOR
OFF HOME
ON SENSOR
PARALLEL I/F
1
In GP-GL command mode
ENABLE “:”,“;”
DISABLE COMD
PEN UP “W”
PEN DOWN
MANUAL SETTING
COMD PRIORITY
2mm BELOW INIT
OUTSIDE BLADE
ENABLE PEN UP
DISABLE MOVE
OFF MEDIA
ON SENSOR
OFF HOME
ON SENSOR
PARALLEL I/F
1
