3 – 9
Step
4
If the cutting plotter has already been turned on
when the push rollers are lowered by raising the
media set lever, a menu for selecting the media
mode appears.
ROLL 1
ROLL 2
Press the
NEXT PAGE
key to proceed the display below.
SHEET
Press the
F1/ORIGIN
key to select the SHEET mode
in which the leading and trailing edges of the media
are detected.
CE2000-120
Step
1
Lower the media set lever to raise the push rollers.
Step
2
While using the front and rear medium alignment
scales as guidelines, load one sheet of the medium
so that its leading and trailing areas are positioned
identically.
Medium alignment scales
Step
3
Adjust the position of the right and left
push rollers to suit the width of the
medium. Position each push roller at its
corresponding edge of the medium so
that it is above the grit roller. Move the
push rollers so that they are positioned
inside the push roller alignment marks
provided. (To move the push rollers,
the media set lever must be in lowered
position.)
Push roller alignment mark
Step
5
After the medium size has been detected, the cutting
plotter awaits cutting data.
If the INTERFACE conditions and COMMAND mode
have not been selected yet, select these settings
at this time (see Section 3.4, “Selecting the
COMMAND Mode and INTERFACE Conditions”).
If they have already been set, proceed to adjust
the cutter pen. After the cutter pen has been adjusted
(see Chapter 4, “PREPARING FOR A CUTTING
OPERATION”), the cutting plotter is ready to perform
cutting so send cutting data from your application
software at the computer.
