3 – 4
3.3 Loading the Medium
The cutting plotter can use film in rolls or in single sheets. Loading the desired medium by following
the pertinent instructions.
3.3.1 Loading a Roll Medium
CE2000-60
Step
1
Lower the media set lever to raise the push
rollers.
Step
2
Place the roll medium on the tray and then pass
the medium’s leading edge from the back of the
cutting plotter so it emerges from the front while
making sure to remove any slack in the medi-
um’s conveyance path.
NOTE: Load the medium so that it passes
over the media sensor.
Media sensor
Step
3
At this point, pull the leading edge out of the
front of the cutting plotter so that it completely
covers the media sensor. If its leading edge
has been pulled out so much that slack cannot
be provided at the back of the plotter, turn the
roll to adjust the length of the medium in front
of the cutting plotter by retracting the leading
edge.
Media sensor
