WALL MOUNT
MULTI-MATERIAL CUTTER
G1089 1/22
Instruction Manual
Model F700-1
Logan Graphic Products Inc., 1100 Brown Street, Wauconda, IL 60084 847-526-5515 www.logangraphic.com
14
Cutting Glass
• Always wear eye protection, gloves, and protective clothing when
handling glass.
• DO NOT USE MATERIAL CLAMP ON GLASS.
• Always load glass from left side support.
• Only score glass on downstroke.
1. Put a drop of oil on wheel.
2. Raise handle into retracted position and install glass cutting
tool (yellow tip).
3. Raise cutting handle above glass.
4. Place glass on left cutting bed (Fig. 45).
5. Slide glass under cutting bars to desired cutting dimension.
6. Lower cutting head handle by pressing trigger. Be careful as handle is
spring loaded and will pull down.
7. Lower cutting head until glass wheel touches top edge of glass (Fig. 46).
8. With left hand holding glass against gusset, move cutting handle to top
edge of glass.
Fig. 45
Fig. 46
Cutting Glass
9. With right hand, gently and smoothly pull cutting head handle
down
(NOT FORWARD).
*Caution
- Do not put forward pressure on cutter as the spring supplies
needed pressure
.
10. Pull back cutting head handle to retracted position.
11. Only score glass one time.
To Separate Glass
1. Do not move glass after scoring.
2. Keep left hand on glass holding it in position.
3. With right thumb, apply increasing pressure on the bottom right edge of
glass near score line until the glass separates (Fig. 47).
* Do not apply pressure at the center of the glass *
4 Clean cutting beds using cleaning brush.
Fig. 47
Score Line
Pressure
