Graphic Products DuraLabel 2000, User Manual

Page: 10 / 56

LOADING THE SUPPLY SPINDLE
1.
With the printer cover open, remove the supply spindle from the printer.
2. Grasping the two sides of the
supply spindle
, gently pull it apart.
3. Slide the supply over the spindle shaft making sure it unwinds in the direction
indicated by the arrows on each side of the supply spindle.
4. Replace the spindle cap on the end of the spindle shaft by pressing the ends
together until they touch the supply roll, making sure the spindle hooks are aligned.
INSTALLING THE SUPPLY SPINDLE IN THE PRINTER
1. To secure the supply, place the spindle hooks in the corresponding slots on
the slotted round bar, as seen in the diagram above.
2.
Press the spindle shaft ends into the spindle slots .
3. Insert the end of the supply between the
platen roller
and the black strip of the
guide plate,
pushing it through the slot at the top of the
printer cover.
4. Carefully close the printer cover without pinching the supply inside, and lock
it in place with the cover release lever .
u
NOTE: Once the printer cover is closed, the printer determines the width of supply, and the supply is
aligned for printing labels.
Guide
Plate
Platen
Roller
Slotted Round Bar Gently push while closing
Spindle
Shaft
End
Spindle
Slot
Supply Spindle
Spindle
Hooks
Spindle
Shaft
Spindle
Cap
4. LOADING PRINTER SUPPLIES cont.
2”
½”
1”