Grand Design Momentum, Owner'S Manual

Page: 163 / 220

161
Slideout Systems
Manually push the slide room in override
1. Locate the circuit board.
2. Unplug both motors from circuit board.
(this releases the motor brake)
3. Push or pull slide room in as desired;
◦
Larger rooms may require several people to push.
◦
Keep both sides of room relatively even.
4. When the bedroom slide is completely in, plug both
the motors back in to the control board (this applies
the motor brake for road travel).
Disengage motors, manually retract room
and travel lock:
1. Locate and remove motor retention screw located
near the top of each vertical column (on the outside
behind the bulb seal).
2. Bend back the wipe seal and visually locate motor.
3. Pull the motor up until disengaged, about 1/2”.
Replace the motor retention screw to hold the
motor in this position.
4. Repeat this process for both sides of the slide room.
5. Push or pull the slide room back in to the opening,
keeping the side of the slide room relatively even.
6. Re-engage motor to be ready for travel.
7. The room must be travel locked to keep room
in place for road travel.