7
GrandCanyonGasLogs.com
Locate the sliver gas control (710-502) as well as the
(2) black plugs, (1) 49-88 (½” MIP x ½” Flare elbow) &
(1) 48-88 (½” MIP x ½” Flare Straight) fittings. Review
Fig_. Using proper pipe compound thread, the 48-88
into the “IN” section of the valve and on the opposite
side thread in (1) black plug. Wrench until both fittings
are tight. With the “IN” of the valve pointed toward
you, insert the 49-88 on the left and the black plug on
the right using proper pipe compound. Wrench until
both fittings are tight. For ALL 2-Burners, Glass Burn-
ers, Kiva Burners, front view and see through the
49-88 should be point back towards the “IN” of the
valve. Fig. 1. For 3-Burners & Jumbo/Jumbo Slimline
Burners (front view and see through) the 49-88
should be pointing up at a 45* degree angle. Fig. 2.
For ALL 2-Burners, Glass Burners, Kiva Burners, front
view and see through the 49-88 should point back
towards the “IN” of the valve. For 3-Burners & Jumbo/
Jumbo Slimline Burners (front view and see through)
the 49-88 should be pointing up at a 45* degree angle.
See Fig. 3 to verify.
Locate the US-4-8 (½” x ½” swivel flare) union fitting.
With an open ended wrench connect the 49-88 on the
valve to the gas inlet on the burner and wrench tight,
see Fig. 4.
Locate the pilot mounting bracket. This can be found
on the back of the 2-Burner & Kiva, side of the 3-Burn-
er and Jumbo Series and the pan of the glass burner.
Screw in using the location holes in the pilot bracket
with self-tapping or #10-32 machine screws.
See Fig. 5, make sure that the pilot hood has (1) flame
pointing towards the thermopile and the other flame
towards the burner.
INSTALLATION
For ALL 2-Burners
For ALL 3-Burners
FIG 1
FIG 2
FIG 3
FIG 4
FIG 5
