2
1
GrandCanyonGasLogs.com
IMPORTANT INFORMATION
CHECK TO BE SURE THAT THE PROPER FUEL GAS IS BEING
USED WITH THIS CONTROL SYSTEM.
The installation, including provisions for combustion and ventilation air, must conform with
local codes, or in the absence of local codes, with the National Fuel Gas Code
(ANSI Z223.1/NFPA 54).
This component and its individual shutoff valve must be disconnected from the gas-supply
piping system when testing at pressures that exceed 1/2 psig. This is accomplished by closing
the gas-supply line valve.
A fireplace screen must be in place when the gas burner system is in operation.
Unless other provisions for combustion air are provided, the screen shall have an opening(s)
for introduction of combustion air.
WHEN GLASS FIREPLACE ENCLOSURES (DOORS) ARE USED, OPERATE
THE BURNER SYSTEM WITH THE GLASS DOORS FULLY OPEN; BOTH
SIDES IF THE FIREPLACE IS A SEE-THROUGH TYPE.
This appliance may be installed in an aftermarket, permanently located, manufactured
(mobile) home where not prohibited by local codes. Installation of appliances designed for
manufactured homes or mobile homes must conform with Manufactured Home Construction
and Safety Standard, Title 24 CFR, Part 3280 in the U.S.; or with CAN/CSA Z240 MH in Can-
ada; or with ANSI/NCSBCS A225.1/NFPA 501A, Manufactured Home Installations Standard
when such as standard is not applicable.
Do not use this appliance if any part has been underwater. Immediately call a qualified service
technician to inspect the appliance and to replace any part of the control system and any gas
control that has been underwater.
TO PREVENT VALVE DAMAGE AND FAILURE:
IT IS CRITICAL THAT THE HEAT SHIELD BE PLACED CORRECTLY OVER THE VALVE..
KEEP LAVA, VERMICULITE, EMBERS, FIRE GLASS AND ALL FOREIGN OBJECTS AWAY FROM THE
PILOT ASSEMBLY, VALVE ASSEMBLY, AND HEAT SHIELD DURING MEDIA PLACEMENT AND AT ALL
TIMES
