Operation
26
3.3. Start Programme
The starting programme determines which placing function the machine will display
when it is switched on. You should select the programme setting that is most commonly
used.
All values that can be changed using the function buttons described above – number of
slices, function – can be saved by pressing the corresponding function key for
2-3 seconds until the beep sounds. The function that was last saved then appears
automatically when the machine is switched back on.
Example:
START Programme
P1
P2
P3
Select function
Stacking
Circular
shingling
Long
shingling
Number of slices
10
10
8
Number of
rows/stacks
2
1
3
Press for 2-3
seconds
If programming is done in the sequence P1
o
P2
o
P3, the following happens after
switching on the machine:
“Long shingling“ function, 3 rows of 8 slices, which is programme “P3”.
On changing functions, i.e. by pressing a different button, e.g. Stacking, the placing
pattern is set for the corresponding function.
The example above would result in the following stacking pattern: 2 stacks of 10 slices.
It is possible to save the various parameters of a function individually by pressing the
corresponding function button for a long time. However, as already mentioned, the most
recently saved programme is always the START programme.
