![background image](http://html.mh-extra.com/html/graco/linelazer-v-hp-auto-series/linelazer-v-hp-auto-series_manual_2250950009.webp)
Application Methods
9
Basic Stall Layout: Stall Calculator
Mark dots near the curb
LAYOUT MODE
1. Move the striper such that the LazerGuide 1700 Start/Stop Laser is at the curb to the left in the illustration shown
above and
GUN
2
(left gun) is on the START reference dot while the striper is facing the left curb.
2. Press the
GUN TRIGGER CONTROL
button and then back up while following the bottom curb until you make a
second dot (at 9.03 ft in this example).
3. Press the
GUN TRIGGER CONTROL
button to stop laying additional dots.
4. Rotate the striper 180 degrees such that the LazerGuide 1700 Start/Stop Laser is directly over the reference dot
that you just laid.
5. Press the
GUN TRIGGER CONTROL
button to start laying dots at the defined width (9.03 ft in this example).
Move the striper toward the FINISH reference dot while following the curb.
6. Press the
GUN TRIGGER CONTROL
button after the last FINISH reference dot is reached to stop laying
additional dots.