![background image](http://html.mh-extra.com/html/graco/linelazer-v-hp-auto-series/linelazer-v-hp-auto-series_manual_2250950015.webp)
Application Methods
15
Radius Stall Layout: Layout Mode
Establish perimeter reference line for start of stalls
NOTE:
For best results, always dot in the same direction.
NOTE:
Minimum engine RPM for placing dots is 2600.
LAYOUT MODE
1. Go to LAYOUT MODE on LiveLook display and select the depth of your stall as the
STALL SIZE
. In this case,
we are selecting 18 ft from the inside curb.
2. Set Gun 1 or 2 to active by pressing the 1 or 2 button on the display so that the red LED is lit.
3. Line the LazerGuide 1700 Start/Stop Laser up with the inside curb and press the
GUN TRIGGER CONTROL
button and then move the striper away from the curb until the outer radius reference dot is placed - 18 ft from the
inside curb in this example.
4. Press the
GUN TRIGGER CONTROL
button to stop placing additional reference dots.
5. Repeat steps 3 and 4 to put down enough reference dots as to define a good enough reference line for the start
of your stalls.