![background image](http://html.mh-extra.com/html/graco/linelazer-v-hp-auto-series/linelazer-v-hp-auto-series_manual_2250950007.webp)
Application Methods
7
Basic Stall Layout: Stall Calculator
Measure for automatic calculation or select desired stall size
STALL CALCULATOR
1. Move the striper to the START point. Line up the LazerGuide 1700 Start/Stop Laser with the START reference
dot and align the LazerGuide 2000 Laser with the Target Box.
NOTE:
Make sure that you calibrate your
LazerGuide 2000 as shown in manual 3A5294 or the 'LazerGuide 2000 Setup & Calibration video.
2. Go to the
STALL CALCULATOR
screen on the LiveLook display, choose your nominal stall width (in this case
we chose 9 ft) and then press the
GUN TRIGGER CONTROL
button to start measuring. Move the striper toward
the FINISH reference dot while keeping the LazerGuide 2000 Laser lined up with the Target Box.
3. Once you reach the FINISH reference dot press the
GUN TRIGGER CONTROL
button to stop measuring.
NOTE:
The LiveLook display is measuring in both the forward and backwards direction so if you go past the
FINISH reference dot, you can back up the striper before pressing the
GUN TRIGGER CONTROL
button to
subtract from the measurement.
4. Use the UP/DOWN arrows to adjust the number of stalls desired (In the example shown, we measured 144.48 ft
and choose 16 stalls each with a width of 9.03 ft).
NOTE:
The LiveLook display automatically transfers the
calculated
STALL SIZE
from the
STALL CALCULATOR
to the
LAYOUT MODE
screen.