LineLazer V LiveLook Display
3A3388A Operation
37
Striping Mode (HP Auto Series)
Operating in Striping Mode
Striper must be running before activating gun trigger
control.
1.
Make sure engine is running.
2.
Use gun activation buttons to select guns and line
type.
3.
Press gun trigger control to begin spraying.
In Automatic Mode or Semi-Automatic Mode the
or
will flash when gun trigger control is pressed to sig-
nal mode is active.
1
12
11
10
9
2 3
4 5
6
7
8
ti27844a
1450 psi
30.8
¹
0.0 gal
9
MIL
Ref. Description
1
Select
a “Favorite”, press for less than one sec-
ond.
Save
a “Favorite”, press and hold for more than
three seconds.
2
Cycles between viewing line width or paint and
space value.
3
Cycles between Manual Mode, Semi-Automatic
Mode, Automatic Mode.
Manual Mode
:
Press and hold gun trigger
control to stripe.
Semi-Automatic Mode
:
Press and release
gun trigger control to stripe the programmed
length one time when in Skip Mode.
Automatic Mode
:
Press and release gun
trigger control to start striping. Press and release
button again to stop.
4
Resets values and starts recording a new job.
5
Job Data Logger, page 47.
6
Scrolls between menu screens.
7
Paint and Space length
OR
line width adjustment
buttons.
8
Auto guns activation buttons.
9
MIL thickness. While spraying “Instant MIL avg” is
displayed. When stopped total “Job MIL avg” is
displayed.
10 Total gallons (liters) sprayed.
11 Total line length sprayed.
12 Pressure
ti27913a
ti27881a
