Setup/Startup
12
3A3388A Operation
Setup/Startup
1.
Perform
Pressure Relief Procedure
, page 11
.
2.
Perform
Grounding Procedure (For Flammable
Materials Only)
, page 11,
if using flammable mate-
rials.
3.
Fill throat packing nut with Throat Seal Liquid (TSL)
to decrease packing wear.
4.
Check engine oil level. Add SAE 10W-30 (summer)
or 5W-30 (winter). See engine manual.
5.
Fill fuel tank.
6.
Set pump switch to
OFF
. Turn engine off.
7.
If removed, install strainer.
8.
Turn prime valve down. Turn pressure control coun-
terclockwise to lowest pressure.
NOTE:
Minimum hose size allowable for proper
sprayer operation is 3/8 in. x 50 ft for LL3900/5900.
9.
Place siphon tube set in grounded metal pail par-
tially filled with flushing fluid. Attach ground wire to
true earth ground. Use water to flush water-base
paint and mineral spirits to flush oil-base paint and
storage oil.
This equipment stays pressurized until pressure is
manually relieved. To help prevent serious injury
from pressurized fluid, such as skin injection, splash-
ing fluid and moving parts, follow the Pressure Relief
Procedure when you stop spraying and before clean-
ing, checking, or servicing the equipment.
ti3307a
ti27610a
ti27611a
Pic 001
(same as pg.10)
ti27504a
ti27612a
ti27614a
4
ti27613a
