![background image](http://html.mh-extra.com/html/graco/linelazer-3400/linelazer-3400_operation-repair-parts_2250934010.webp)
Pressure Relief Procedure
10
3A4587B Operation, Repair, Parts
DAILY:
Check engine oil level and fill as necessary.
DAILY:
Check hose for wear and damage.
DAILY:
Check gun safety for proper operation.
DAILY:
Check pressure drain valve for proper opera-
tion.
DAILY:
Check and fill the gas tank.
DAILY:
Check level of TSL in displacement pump pack-
ing nut. Fill nut, if necessary. Keep TSL in nut to help
prevent fluid buildup on piston rod and premature wear
of packings and pump corrosion.AFTER THE FIRST 20
HOURS OF OPERATION:
Drain engine oil and refill with clean oil. Reference
Honda Engines Owner's Manual for correct oil viscosity.
WEEKLY:
Remove engine air filter cover and clean ele-
ment. Replace element, if necessary. If operating in an
unusually dusty environment: check filter daily and
replace, if necessary.
Replacement elements can be purchased from your
local HONDA dealer.
AFTER EACH 100 HOURS OF OPERATION:
Change engine oil. Reference Honda Engines Owner's
Manual for correct oil viscosity.
SPARK PLUG:
Use only BPR6ES (NGK) or
W20EPR-U (NIPPONDENSO) plug. Gap plug to 0.028
to 0.031 in. (0.7 to 0.8 mm). Use spark plug wrench
when installing and removing plug.
Front Wheel Alignment:
Align front wheel as follows:
1. Loosen cap screw (114).
2. Position front wheel left or right, as necessary, to
straighten alignment.
3. Tighten cap screw (114). Push striper and let striper
roll with hands off of striper. Note: If striper rolls
straight or veers right or left. Repeat steps 1 and 2
until striper rolls straight.
ti6392a
114