Warnings
4
309834W
SKIN INJECTION HAZARD
Spray from the gun, leaks, or ruptured components can inject fluid into your body and cause extremely
serious injury, including the need for amputation. Fluid splashed in the eyes or on the skin can also
cause serious injury.
•
Fluid injected into the skin might look like just a cut, but it is a serious injury.
Get immediate surgi-
cal treatment.
•
Do not stop or deflect fluid leaks with you hand, body, glove, or rag.
•
Follow the
Pressure Relief Procedure
in your separate equipment manuals whenever you are
instructed to: relieve pressure; stop dispensing; clean, check, or service the equipment; or install or
clean a nozzle.
•
Tighten all the fluid connections before operating the equipment.
•
Check the hoses, tubes, and couplings daily. Replace worn, damaged, or loose parts immediately.
Permanently coupled hoses cannot be repaired; replace the entire hose.
•
Always wear eye protection and protective clothing when installing, operating, or servicing this dis-
pensing equipment.
•
Never wipe off build-up around the nozzle or inlet cap until pressure is fully relieved.
TOXIC FLUID OR FUMES HAZARD
Hazardous fluids or toxic fumes can cause serious injury or death if splashed in the eyes or on the skin,
swallowed, or inhaled.
•
Provide fresh air ventilation to avoid the buildup of vapors from the fluid being dispensed.
•
Know the specific hazards of the fluid you are using.
•
Store hazardous fluid in an approved container. Dispose of hazardous fluid according to all local,
state and national guidelines.
•
Always wear protective eyewear, gloves, clothing and respirator as recommended by the fluid and
solvent manufacturer.
•
Avoid exposure to heated material fumes.
HOT SURFACE AND FLUID HAZARD
Heated fluid can cause severe burns and can cause equipment surfaces to become very hot.
•
Wear protective gloves and clothing when operating this equipment in a heated system.
•
Do not touch the metal heat sink when the surface is hot.
•
Allow the equipment to cool thoroughly before servicing.
•
Some heated systems are designed to dispense Polyurethane (PUR) heated materials. PUR Sys-
tems are supplied with ventilation hoods, and require proper ventilation and specifically designed
system components.
WARNING
