Reassemble the Center Section
1. Lubricate and install a u-cup (26) in each air
cover (7). U-cup lips must face out of center
housing.
2. If the shaft bearings (23) were removed, install
new bearings. Use an arbor press or the bearing
press tool supplied with the kits (PN 17H368).
3. Lubricate and install an o-ring (29) in each air
cover.
4. The piston assembly should still be one piece. If
the two shafts came apart during disassembly,
follow these instructions to reassemble. The
shaft stud will be attached to one shaft. Clean
the threads and apply primerless, high-strength
(red) thread locker (Loctite 263 or equivalent).
Install the shafts in the center of the piston and
hand tighten them together. Then, clamp the
flats of one shaft in a vice, and torque the other
shaft to 50–55 ft-lb (68–75 N•m).
1
Apply high-strength (red) thread locker (Loctite 263 or equivalent) to the threads.
2
Torque to 50–55 ft-lb (68–75 N•m).
24
333015E
Summary of Contents for Endura-Flo 4D150
Page 9: ...Installation Notes 333015E 9...
Page 30: ...Parts Parts 30 333015E...