Notes
12
308798ZAA
15. Soak all leather packings in SAE 30W oil for 1 hour
minimum prior to assembly. Stack male gland (219)
on piston rod. Alternately stack UHMWPE (208) and
leather (218) packings (note orientation) on piston
rod. Install female gland (217). Install backup washer
(216) and u-cup (209) (note orientation) on piston
valve (210). The special sealing patch on piston
valve threads is good for four repackings. Use thread
sealant on piston valve threads after four repackings.
16. Install ball (206) in piston rod.
NOTE:
If thread
sealant is applied to piston valve threads, make
sure none gets on ball. Install piston valve on piston
rod. Torque as follows:
17. Grease piston packings.
18. Slide piston assembly into bottom of sleeve. Make
sure u-cup is not rolled over or damaged.
19. Grease top inch or two of piston rod that will go
through the cylinder throat packings.
Models
Torque
239923
27 +/- 3 ft-lb
240291 & 240800 55 +/- 3 ft-lb
240217
55 +/- 5ft-lb
210
218
206
208
219
217
229
216
ti3941a
Not used on
239923,
243344 &
243345
216
209
ti7575b
206
NOTICE
Do not slide piston assembly into top of sleeve as this
may damage piston packing.
ti7578c
ti7579a
Summary of Contents for 239923
Page 9: ...Notes 308798ZAA 9 Notes ...