-19-
Back Lever
Middle Lever
Front Lever
1/4" Washer
3/16" Washer
1/4" Nyloc Nut
Back Lever
Middle Lever
Front Lever
1/4" Washer
3/16" Washer
1/4" Nyloc Nut
Step 15-1
Step 15-2
Step 15-3
Nylock Nut Rules:
Nylock nuts are
used to allow the parts being bolted
together to move. Nylock nuts will not
loosen after threaded onto a bolt. So,
whenever a nylock nut is used keep
in mind that one of the parts will
need to pivot freely. This being
the case, remember to not over
tighten Nylock Nuts.
Fig. 15-1
Fig. 15-2
15-1:
•
a -
Attatch the Back Lever to the Bottom Handle by inserting a 50mm Connector Bolt though
the hole near the middle of the lever. •
b -
Put a 1/4” washer onto the bolt. •
c -
Insert the bolt
through the hole below the bump on the Bottom Back Handle (Fig. 15.2). •
d -
Place a 3/16”
washer onto the bolt. •
e -
Finally fasten the lever to the handle with a 1/4” Nylock nut.
15-2:
•
a -
Insert a 50mm connector bolt through the second hole right above the cut out part on
the Middle Lever, (as shown below). •
b -
place a ¼” washer onto the bolt. •
c -
Insert the bolt
through the hole on the Right Top Handle, (on the bump towards the right end of the Top Handle.)
•
d -
Slide a 3/16” washer on the end of the bolt, and secure into place with a nylock nut.
15-3
•
a -
Insert a 50mm connector bolt through the second hole (closest to the middle) on the
Front Lever. •
b -
Place a ¼” washer onto the bolt. •
c -
Insert the bolt through the furthest
forward hole on the Right Top Handle. •
d -
Slide a 3/16” washer onto the end of the bolt followed
by a nylock nut.
NOTE:
Steps 15 -18 are necessary if using your machine foot pedal to run your machine. If you are
bypassing your foot pedal by using a speed control device, or stitch regulator you can skip to step 19.
**THE PEDAL PUSHER CAN ONLY BE ATTATCHED TO THE RIGHT SIDE OF THE
CARRIAGE.**
Step 15: TP Handle Assembly
Parts Needed:
1- TPUH Assembly (Step 14)
1- Front Lever
1- Middle Lever
1- Back Lever
3- 50mm Connector Bolt
3- ¼” Washer
3- 3/16” Washer
3- ¼” Nylock Nut
