-18-
30mm Connector Bolt
45mm Connector Bolt
Lamp Holding Cross Brace (LHCB)
Back Handle Cross Brace (BHCB)
Right - Top Handle
Left - Top Handle
1/4" Square Nut
30mm Connector Bolt
45mm Connector Bolt
Lamp Holding Cross Brace (LHCB)
Back Handle Cross Brace (BHCB)
Right - Top Handle
Left - Top Handle
1/4" Square Nut
Fig. 14-2
Fig. 14-1
step 14-2
Step 14-3
Step 14-5
Step 14-7
Step 14-5
14-1:
Place the BHCB between your Bottom Handles with the
“T” slots facing down.
NOTE:
If you are going to use a speed control device, or stitch
regulator use the Back Handle Narrow Cross Brace instead of the
Back Handle Cross Brace.
Fig. 18-1
shows the installed Back Handle
Narrow Cross Brace installed.
14-2:
Take your Right and Left Top Handles and put two of the 45mm connector bolts through the
back two holes on each handle, as show below.
14-3:
Place a nut inside each of the “T” slots in the BHCB.
14-4:
Thread the bolts through the holes on the Right and Left Bottom Handles and into the nut in
the BHCB.
14-5:
Place a nut inside each of the “T” slots in the LHCB.
14-6:
Put the LHCB between the Right and Left Top Handles. **
NOTE
you will have to pry the
handles apart to get the Spacer in.**
14-7:
Once you have the spacer in put a 30mm connector bolt through the hole and tighten it
securely into the nut.
Step 14: TP Upper Handle (UH) Assembly
Parts Needed:
1- TPLH Assembly (Step 13)
1- Right Top Handle
1- Left Top Handle
1- Lamp Holding Cross Brace (LHCB)
1- Back Handle Cross Brace (BHCB)
1- Back Handle Narrow Cross Brace (BHNCB)
2- ¼” x 30mm Connector Bolts
4- ¼” x 45mm Connector Bolts
6- ¼” Square Nut
