-14-
Left Pole
Mount End
Right Pole
Mount End
Plastic Knob Assembly
1-1/4" Fender Washer
Plastic Knob Assembly
1-1/4" Fender Washer
Plastic Knob Assembly
1-1/4" Fender Washer
Rail to Pole Mount End Assembly
Complete Lower Frame Assembly
1/4" X 1-1/2"
Truss Bolt
Ratchet Stop
Fig. 10-2
Fig. 10-3
10-1:
Attatch Rail
to Pole Mount End
Assembly to the Complete
Lower Frame Assembly
by first placing the Rail to
Pole Mount End Assembly
between the upper portion of
the outer legs of the Complete
Lower Frame Assembly.
10-2a:
Next insert a Plastic
Knob Assembly through the
slot in each of the outer Legs,
and into the hole in the
pole mount end that has a
threaded metal insert in it.
Tighten the knobs. (You may
need to loosen the bolts attatched in
step 3-1 to get the holes to line up.)
10-2b:
Tighten the bolts from step 3-1
in the outer Legs if you loosened them
to gain proper hole alignment in step
10-2a.
Step 10: Complete Frame Assembly
Parts Needed:
1- Rail to Pole Mount End Assembly
1- Complete Lower Frame Assembly
4- Plastic Knob Assembly
4- 1-¼” Fender Washers
Fig. 10-1
10-3:
Attatch ratchet stops to the Left
Pole Mount End using 1-1/2” Truss Bolts.
(Fig. 10-2, Fig. 10-3)
10-4:
HAND TIGHTEN ONLY! Over
Tighting these bolts may damage the Pole
Mount End.
NOTE:
Notice that 2 of the rails on the Rail to Pole
Mount End assembly are closer together than the other
one. When the Rail to Pole mount end assembly is
attatched to the Complete Lower Frame assembly the
side of the frame that has the 2 rails closest together
becomes the front of the frame. Be careful to locate
the front of the quilting frame away from walls or other
obstructions, to allow easy acces to the front of the
frame while quilting.
