Page | 68 GRACE MX Manual 2013
Assembling the rear wheel
Remove the transport lock. Carefully put the
drive belt on the belt sprocket of the rear wheel.
Put the rear wheel into the dropout.
Position the rear wheel in such a way that the
torque support (gib washer) slides into the
dropout internally on the right and externally on
the left.
When you are doing this, please ensure that the
brake slides properly between the brake pads.
The rear wheel axle must be placed in both dropouts at the same time and
the tabs of the torque supports must be in the groove.
Attach both hub axle nuts and bolts and tighten them in turn with a (15 mm) spanner and a
torque of 30 – 40 Nm. Please see also adjustments torque table page 80.
Assembling the gear system
Please follow the guidelines in the manual for the NuVinci N360 on page 11 in
the chapter entitled Assembly and Disassembly of the Rear Wheel
