Ø
First connect the Angled Wood Brackets to the Left and Right End pieces.
Ø
The short leg of the Angled Wood Bracket connects to the End piece using the 45 mm connector bolt,
washer and nylock nut (as pictured) with the longer leg of the Angled Wood Bracket pointing down.
Ø
Next connect the Straight Wood Bracket to the Left and Right back Legs using the 50mm connector bolt,
washer and nylock nut (see right).
Ø
Be sure the cut-out surrounding the bottom hole of the Straight Bracket faces toward the inside of the
frame.
Ø
Now connect the Straight and “L” Wood
Brackets together using the 45mm connector bolt,
washer and nylock nut.
Ø
With this bracket assembly in place on both the
Left and Right Ends, you are ready to insert your
pole. Follow pole assembly instructions on pages 11 and 12 (Assemble the 4
th
Pole so it is the same length
as the other three). Be sure to put a nylon washer on each end of the pole.
Completely tighten
all nylock nuts in this
assembly
16
1/4" X 55mm
Connector Bolt
1/4" X 45mm
Connector Bolt
1/4" Nyloc
Nut
1/4" Flat
Washer
1/4" Flat
Washer
1/4" Nylock
Nut
1/4" X 55mm
Connector
Bolt
1/4" X 45mm
Connector
Bolt
4th Rail Mounting
Brackets on Right Side
Inside View
1/4" X 55mm
Connector
Bolt
1/4" X 45mm
Connector
Bolt
1/4" Nyloc
Nut
1/4" Flat
Washer
4th Rail Mounting
Brackets on Left Side
Outside View
4th Rail Installed
Back of frame
