S
TEP
7: P
OLE
TO
F
RAME
A
SSEMBLY
P
ARTS
N
EEDED
:
3 – A
SSEMBLED
P
OLES
3 – R
ATCHET
S
TOPS
3 – 1⁄4”
X
1 1⁄2” T
RUSS
B
OLT
***IMPORTANT: Before complet-
ing the next step, keep in mind that
the truss bolt should be about 1/4”
too long. THE BOLT SHOULD
NOT BE TIGHTENED WITH
ANY TOOL. TO AVOID DAM-
AGE, ONLY FINGER-TIGHTEN
THIS BOLT.
Ø
Install the three ratchet stops as illustrated using the truss bolt into the metal inserts of the Right Pole
Mount End.
Ø
TIP: Observe the direction of the Ratchet Wheel
teeth as illustrated and follow while assembling the
quilting poles to the Pole Mount Ends.
Ø
Slip a Ratchet Wheel onto the end of one “D” Pole.
Position the end of the pole that
does not have the
Ratchet Wheel on it
into the LEFT FRONT HOLE
in the Left Pole Mounting End (just inside the lamp
holder). (NOTE: There are three hole options giving
you slight height adjustment. Be sure to place each
end in the same level hole).
Ø
As you position the Ratchet Wheel end of the pole
into the Right Pole Mounting End, pull the Quick
Release Hook back, and then release it into the hole.
Test the Ratchet Stop to make sure it fits snug into the
teeth of the wheel. If it does not, slip the wheel off
and flip it around so the teeth go the other direction.
Ø
Complete the above steps for the two other poles with
Ratchet Wheels. Remember, the wheel rotation will be
opposite from the wheel on the front pole.
13
Back Rail
Middle Rail
Front Rail
Rail Insertion
Middle Rail
Back Rail
Front Rail