Grabo PRO-LIFTER 20, Operator'S Manual

Page: 17 / 164

17
GRABO PRO-LIFTER 20 | Operator’s manual
sudden detachment. The motor should
always be on.
d) Always store the seal covered with a hard
cover. The seal can be easily damaged
by sharp corners and edges when in
storage.
The seal should not be stored
with sharp tools or in contact with any
hard objects (e.g. inside a toolbox).
e) Do not dip the seal in water. The rubber
foam seal is slightly water absorbent.
Unless it is fully dipped in water and
soaking wet, slightly soaking the seal with
water will not damage its performance. If
it is soaked in water, it can be squeezed
by hand like a sponge to dry without
damage. It is advisable to use a dry seal to
avoid water getting sucked into air ducts
and inside the body.
! Do not dip or use the seal in the presence
of any oil-based products. Oil and oil
products (machine oil + lubricants) will
permanently damage the seal and cannot
be removed. If the seal has absorbed oil,
it should be disposed of safely, the base
should be cleaned, and the seal replaced.
! Do not use or store the seal in the
presence of chemical solvents. Kerosene,
acetone, turpentine, benzene, acids, etc.
and even their fumes in closed spaces
or thin layers on surfaces can melt the
seal and damage its structure and cause
failure.
EXPLANATION OF SYMBOLS USED ON TOOL
➋
Read the operator’s manual before use
➌
Wear protective shoes and gloves
➍
Do not dispose of the tool together with household waste material
NOISE EMISSION/VIBRATION
• A-weighted sound pressure level LpA=79.4 dB(A), uncertainty K=3 dB(A). A-weighted
sound power level LwA=71.4 dB(A), uncertainty K=3 dB(A).
• Vibration total value=1.240 m/s
2
, uncertainty K=0.11 m/s
2
. The declared vibration total
value has been measured in accordance with a standard test method and may be used for
comparing one tool with another. The declared vibration total value may also be used in a
preliminary assessment of exposure.
! WARNING: The vibration emission during actual use of the power tool can differ from
the declared total value depending on the ways in which the tool is used. It’s necessary to
identify safety measures to protect the operator based on an estimation of exposure in the
actual conditions of use (under consideration of all parts of the operating cycle such as
the times when the tool is switched off and when it is running idle in addition to the trigger
time).
TRANSPORT
The lithium-equivalent content in the batteries is below applicable limit values. Regulations
governing hazardous goods may be relevant when transporting several batteries. In this case,
it may be necessary to comply with special conditions, such as those governing packaging.
Always make sure the national installation regulations are observed.