Local Subnet:
If the
Enabled
checkbox is checked, the ETH0 subnet will be used for
encryption based source IP address. If not checked, no local subnet will be used and
encryption will be done when packets with source IP of the Logic-5000’s occur. This is
useful for AAVL reports that get out directly from the Logic-5000.
Encryption:
This is to determine the use of AES-128 or AES-256 encryption.
Pre-shared Key:
Matching key residing on the remote server.
5.7.4.3.
Tunnel Table
This is the table of configured tunnels. To delete an entry, click the corresponding
Delete
Entry
link.
Figure 29
– Advanced Settings -> IPsec, Tunnel Table section
5.7.5.
Advanced Settings – Remote Admin
Figure 30
– Advanced Settings -> Remote Admin page
Remote Configure:
Selecting Enable will allow remote access to the modem’s
configuration screens through the cellular network connection. Selecting Disable will shut off
the ability to remotely access the modem’s configuration screens.
Incoming Port:
Change the port of incoming requests. It is not necessary to change this
parameter unless it conflicts with other devices on the network.
Admin Password:
Set the password for
BOTH
remote login and local login. The password
must be entered twice for the password to change.
Page 45 of 59
