18
5. Hook the pulp container into the drain edge of the juice
collecting container and place it onto the pulp container holder.
6.
Place the cover on the appliance so that it covers both the juice
collecting container and the pulp container.
7. Flip the retaining bracket up. It must audibly and noticeably lock
into the lock nose.
8.
Remove the protective cap from the juice spout.
9.
Put the lid onto the meassuring jug so that an opening on the
side of the jug is formed.
10.
Place the jug as close as possible to the appliance with the opening around the juice spout.
11.
Insert the mains plug in an easily accessible socket.
Your juicer is now ready for use.
Juicing
❐
Only use the plunger and never your fingers for pushing the fruits
or vegetables into the juicer! Beware of injury! Also do not use any
other utensils such as a spoon or the like.
❐
Do not forcefully push fruits or vegetables into the fill chute!
❐
In the event of an overload, the device will automatically turn off.
Afterwards, disconnect the mains plug from the socket and allow
the unit to cool off for approximately 3-4 hours before reactivat-
ing it.
❐
Use the device continuously for no more than 3 minutes without
stopping. Afterwards allow it to cool off for 7 minutes before you
continue to use it.
❐
Always deactivate the device before you open the cover and wait
until the cutting sieve has come to a stop.
1.
Set the switch to the desired speed:
Level
0:
the device has been deactivated.
Level
1:
for soft fruits or soft vegetables,
Level
2:
for hard fruits or hard vegetables.
2.
Insert the fruits or vegetables to be juiced into the fill chute. For
this, observe the notes under “Preparing Food”.
3.
Use the plunger in order to push down the fruits/vegetables. Make sure that you turn the
plunger so that its groove fits into the fill chute properly. Push the food gently.
Too much
pressure could result in less juice produced and damage to the device.
4.
The juice will run into the cup and the pulp and seeds will be conveyed into the pulp con
-
tainer. Turn the device off (level
0
) as soon as the desired amount of juice has run into the
cup or the pulp container is full.
5. After use, disconnect the device from the power supply and clean it (see section “Cleaning
and Storage”).
6.
Fill the juice made into a glass and enjoy it, ideally while it’s still fresh. You can also keep the
juice in the refrigerator for a short period of time.
02088+02089_DE-GB-FR-NL_V0.indd 18
18.11.09 14:46