***IMPORTANT NOTICE FOR TREEHOUSE KIT PLAYSETS***
Read all instructions thoroughly before beginning construction, this is very important. The
“Treehouse
Add On K
it” (1525)
box will require you to deviate slightly from the standard kit
instructions.
Typical deviations include:
1) The Telescope that is usually on the front of the set on the Front face board (arched board)
must be moved to another location on the set. Additional instructions to mount the Telescope are
included in the play set Appendix or with the
“
Treehouse Add On Kit
”
manual. Mount the
Telescope along the top of any of the railings that do not interfere with any areas that are activity
openings.
2) DURING ROOF CONSTRUCTION:
Both Roof Peak Support Triangles will be required to build the main roof. Then the Roof Peak
Support Triangle is removed from the inside of the front Roof Supports on the front of the play
set. It will be necessary to re-use the Roof Support Triangle to connect the roof supports from the
Treehouse Kit to one another.
The Plastic Sunburst must be left off the front of the play set until after the
“
Treehouse Add On
Kit
”
is installed onto the front of the play set.
3) Flag Kits which normally reside on the front of the front corner posts at the top should be
relocated to the front slats of the
“Treehouse Add On Kit”
Wood/Accessory and Hardware Lists:
These lists for the
“
Treehouse Add On Kit
”
are in the Appendix at the end of your play set
instruction manual or they are included with this sheet.
Steps to complete the
“
Treehouse Add On Kit
”
:
The instruction steps for the
“
Treehouse Add On Kit
”
are in the Appendix at the end of your play
set instruction manual or they are included with this sheet.
If you are adding the “Treehouse Add On Kit” to a playset that is already built
:
It will be necessary to remove the Flags and Plastic Sunburst from the front side of your playset
wood roof.
Then remove the 5/4 x 10” Roof Peak Support triangle from the inside of the front Roof
Supports. Keep these pieces and hardware since most will be reused during the construction
process.
Fill in the holes in the corner posts from the Flags with clear silicone (not included). If you wish to
fill the holes with a fastener then use #8 x 1” countersunk head screws with silicone in each hole.
You will need to purchase these screws at your local home center if you choose this option.
Fill any small holes in the Roof Supports leftover from removing the Plastic Sunburst with wood
filler. Use a stainable wood filler suitable for outdoor use. Then stain the wood filled spots with a
suitable matching color of stain.