MDE-LEDI-NETWORK-TDS-4099V3.0
77
E
NG
LI
S
H
►
Updating the SSH interface
The SSH interface must be enabled in the device settings to carry out this operation.
1- Open a terminal (Start menu
→
run
→
“
cmd
”)
Type "
pscp <firmware path> root@<module IP address>:/
", ENTER
If PSCP is not available, install the Putty packet which is downloadable from:
https://www.chiark.greenend.org.uk/~sgtatham/putty/latest.html then repeat step 2.
Password: “
gtmt
”
9- Do not switch off the module before it has finished restarting.
Please read the “WARNINGS” note carefully.
☛
WARNINGS
Do not use or attempt to operate the product once the update has been initiated.
More specifically, do not interrupt the product’s functioning or reboot it during the
update. The device will reboot on its own when required.
Please also make sure to secure the power source(s) before and during the update.
The product can be used again when the Web pages can be loaded again in the browser and
the Up Time information displayed on the Index page is more than 1 minute.
During the update, the product will reboot once or twice. Theses reboots trigger the
reset of the Up Time. Therefore, the value displayed on the Index page must be
coherent with that information.
When in doubt, please wait 5 minutes before rebooting the product. This duration
corresponds to the approximate time needed for two secured product reboots
following an update.
Ignoring the recommendations above may result in corrupting the network cards (NTP
output cards or main/management Ethernet port). The related repairs will be billed
and are not covered by the warranty.
