22
EN
overheating of water and consequently to excessive pressure.
Circulation leads to additional heat loss in the water tank.
This product contains fluorinated greenhouse gases. Hermetically sealed.
Dear buyer, thank you for purchasing our product.
PRIOR TO THE INSTALLATION AND FIRST USE OF THE HOT WATER STORAGE TANK
WITH THE HEAT PUMP, PLEASE READ THESE INSTRUCTIONS CAREFULLY.
This storage tank has been manufactured in compliance with the relevant Standards, which allow the manufacturer the use of
the CE sign. Its basic technical characteristics are indicated on the label on the backside of the indoor unit – boiler, and on the
outdoor unit – aggregate, next to the electric terminal box.
The connection of the storage tank with the heat pump to the plumbing and power networks must be carried out by qualified
staff only.
All repairs and maintenance work in the interior of the storage tank, as well as limestone removal or testing or
replacement of the corrosion protection anode, may only be carried out by an approved maintenance service
provider.
Be especially careful when following instructions for potential errors and safe use of the heat pump.
Store this booklet for times of doubt upon the functioning or maintenance.
The installation manual is available on our webpage http://www.gorenje.com or the webpages per country in the service and
support section.
Authorised maintenance personnel are available for occasional maintenance. They will help you with their vast experience.
The hot water storage tank is designed in a manner which allows using the following heating sources:
• Central heating storage,
• Solar power,
• Electric heater.
USE
This unit is designed for production of sanitary water in households and at premises where daily consumption of hot water
(50 °C) does not exceed 400 l to 700 l.
The set temperature should suffice actual needs. Recommended temperature settings
are between 45 and 55 °C. Higher temperatures are not recommended as they reduce the efficiency (COP) and extend
the time of heating or increase the number of operating hours.
The operation of the heat pump is completely
automatic.
The appliance must be connected to water supply mains and to the power supply grid. We recommend leaving enough space
between the floor and unit as to provide easy access to the Mg anode (for maintenance or replacement purposes – Fig. 1).
The heat pump may not be used for purposes other than those defined in these Instructions. The unit is not designed for
industrial use or use in rooms where corrosive or explosive substances are present.
The manufacturer shall not assume any liability for damages caused by incorrect installation or misuse that are not in
compliance with the Instructions for installation and use.
The
instructions for use
are a component and important part of this product and must be delivered to the customer. Read the
warnings carefully, as they contain important directions related to safety during operation, use and maintenance.
Keep these Instructions for later use.
Your indoor unit’s type marking is indicated on the label on the upper back side of the indoor unit – boiler and the outdoor unit
– aggregate, next to the electric terminal box.
Once the packaging is removed, check the contents. When in doubt, contact your dealer. Never let children play with the
packaging parts (clamping, plastic bags, expanded polystyrol, etc.) – potential risk. Make sure to remove and dispose of the
packaging safely and in an environmentally friendly way.
The appliance is not intended for use in closed space, containing corrosive and explosive materials.
Always transport the outdoor unit of the heat pump in an upright position; exceptionally, it may be tilted by 35° in
all directions. Be careful not to damage the housing or the vital component parts of the appliance during transport.
STORAGE AND TRANSPORT
Store the outdoor unit – the aggregate of the heat pump in an upright position, in a clean and dry place. Store the indoor unit –
the boiler in an upright position, in a clean and dry place.
