440
2
7
0
• Veneer or other fi nish of the furniture the appliance is
being built into should be processed with heat-resistant
glue (100°C); otherwise, high temperatures may cause
them to deform.
• Before installing the appliance, remove the back wall
from the piece of kitchen furniture the appliance is
being built into, along the entire length of the cutout.
• The installation cutout should be dimensioned as
indicated in the fi gure.
• The bottom panel of the piece of kitchen furniture (max.
530 mm) should always be shorter than the side walls to
enable adequate air circulation.
• Level the piece of furniture the appliance was built into
with a spirit level.
• The piece of kitchen furniture the appliance is built into
must be secured against movement, e.g. attached to the
adjacent pieces of kitchen furniture.
• Push the appliance into the kitchen furniture element
enough that the guides for the screws that are inserted
in the oven frame holes are placed against the kitchen
element side walls.
• When attaching the appliance, make sure the screws
are not fastened too strongly as this may damage the
furniture or the appliance enamel coating.
Installation
• The appliance may only be connected by a qualifi ed expert.
• The appliance should be fi tted with a device that disconnects it from all poles of the
home network (an omnipolar switch), with at least 3 mm of distance between the
contacts in open position. LS-switches or fuses are appropriate.
• To connect the appliance, use the rubber mains cords (type HO5RR-F with the green/
yellow earth wire), PVC insulated (type HO5VV-F with the green/yellow earth wire), or
other equivalent or superior cables.
• Veneer, glue, or plastic fi nish of the furniture next to which the cooker is installed,
should be treated heat resistant (>75°C). If the veneers are not high temperature
resistant, they may be deformed.
• Packaging (plastic foil, polystyrene, etc.) must be kept out of reach of children, as it
can be a source or threat to them. Small parts can be swallowed by the children, and
the foils are hazardous because of the risk of suff ocation.
Important warnings
30
INSTRUCTIONS FOR INSTALLATION AND
CONNECTION
Summary of Contents for simplicity BO71SY2B
