STEP 3 - MOUNTING
3.1
Shim frame to level the underside of the outer frame to prevent racking/twisting (shims
included).
3.2
Verify frame is square by checking diagonals.
3.3
Torque frame attachment hardware to 260 lb ft, Turn-of-Nut method is acceptable
3.4
If beams are not factory prepped, end prep incoming beams. Additional parts required from
factory (see Appendix A on pages 11-14 for detail).
3.5
Use provided 3/4” A325 bolts, washers and nuts to loosely assemble monorail beam to
switch. Do not tighten yet.
3.6
Shim inlet and outlet beams 0” to 1/32” lower than switch track.
3.7
Set gap between inlets and switch track is 1/8” maximum. Ensure that beam ends do not
rub or bind as they pass each other.
3.8
Once beam is positioned, tighten beam attachment hardware. Torque to 260 lb ft. Turn-of
Nut method is acceptable.
5
11/2018
Diagram 3A.
Shim detail.
OUTLET
INLET
Summary of Contents for Tarca I Series
