English
•
Owner´s manual
28
• Drive away from people.
• When starting, pay attention to road grade and other conditions, and drive at a safe speed.
• Fast forwarding, rapid acceleration, sharp turns and other operations are prohibited to avoid causing
injury to the driver or accidents such as skidding or vehicle rollover.
• On the sloping road surface, the shift lever and throttle lever should be set to low gear for driving,
otherwise the driver may be easily injured or the vehicle may skid and/or overturn.
• Do not cross a sloping road, as this may cause the vehicle to skid or overturn. Do not turn on the inclined
road surface, as this may cause the vehicle to reverse, skid or overturn.
• If the view is not clear or the road is narrow, steep, or in poor condition, follow the instructions and make
a safety confirmation before driving.
• Do not turn the main switch “OFF” while driving.
Variable speed method
1) Verify that the vehicle is in a stationary state and that speed changes do not exceed permitted loads
and ramps.
• The vehicle must be stationary during variable speed operation.
• Operate the gear shift accurately. If the gear shift actuation is not correct, the gear shift will fall out easily.
2) Depress the clutch rod first, confirm that the shift rod is in place, and then walk into the driving vehicle.
NOTE:
Refer to “technical data” for the gear position corresponding to each variable speed position.
NOTE:
When the shift lever goes hard, press the clutch lever; and try the shift lever again.
Parking method
• Emergency parking is not allowed as it can easily cause the vehicle to skid and overturn.
• Please stop if the road is dangerous.
• Do not park on inclined roads, you must tighten the wheels when you have to do it.
1) Put the throttle in the low speed position and reduce the vehicle’s speed.
2) Release the clutch bar and stop the vehicle.
3) Move the gearshift lever to the position
[0]
.
4) Turn the main switch to OFF” position and stop the engine.
5) Set the fuel switch to the “OFF” position.
CAUTION:
When the engine is running at low RPM, the spark plug is prone to accumulate carbon
residue. Therefore, when the engine is in a state of low rotation for a long time it will move at high speed
before shutting down to remove carbon residue.
