13
TV OPERATION
CAUTION
Never tamper with any components inside
your set, or any other adjustment controls
not mentioned in this manual. All television
receivers are high voltage instruments. Your
PICTURE TUBE is highly evacuation. If
broken, glass fragments will be violently
expelled. Scratching. chipping or undue
pressure is dangerous and should be
avoided. When you clean up or dust the
PICTURE TUBE FACE or CABINET, the
power cord should be pulled out from the
wall socket, then wipe the receiver with dried
soft cloth. During thunder and lighting,
unplug the power cord and aerial cable to
prevent your TV set from damage. All
"internal work" on your unit should be
performed only by TV service personnel.
INSTALL TV AERIAL
To have a better receipt of TV broadcasting
programme, insert the supplied indoor UHF
loop aerial into the TV aerial holder at the rear
of the unit and connect the aerial cable to the
nearby 75 ohm TV aerial input socket. Rotate
the loop aerial and adjust the loop angle to
obtain a best picture in the TV screen.
Alternatively, you may connect an outdoor TV
aerial to the TV aerial input socket.
OPERATION INSTRUCTIONS
Set the Function mode to TV (TV LED
indicator will illuminate). The picture will
appear after a few seconds. The programme
channel number is displayed on the top right
hand corner of the screen if OSD button on
remote control is pressed.
MENU BUTTON
1. Press this button to select menu. PRESET,
PICTURE, SYSTEM and TIME menu can
be selected cyclically.
2. After entering a menu, you can select the
item to be adjuste with the PROG. +/-
buttons, adjusting the selected item by
using VOL. +/- buttons.
* The item selected will change to blue.
Preset menu (Channel Storing)
PRESET
CHANNEL
00
SKIP
OFF
BAND
VL
ASM.SIF
6.5M
FINE
SEARCH
ASM
1. CHANNEL
The channel being watched can be stored.
To adjust the channel number use the VOL
+/- buttons.
2. SKIP
Can be set “ON” by VOL +/- buttons. If
you want to cancel (skip) the channel
being watched.
3. BAND
You can select V-L, V-H or UHF
- Note: UK is UHF.
4. ASM SIF
You can select 6.0M, 4.5M, 6.5M or 5.5M
- UK is 6.0M.
5. FINE
To tune in a weak TV station manually.
6. SEARCH
Select a channel (see above CHANNEL)
and press VOL +/- Buttons to start TV
station searching. The VOL- button
searches for a lower frequency TV station
signal and VOL+ button for higher
frequency. When a TV station signal of
sufficient strength is received, the searching
will stop and that TV station programme will
be stored in the selected channel.
+
Preset Menu
Picture Menu
Exit Menu
Time Menu
System Menu
GOODMANS Product Information Helpline : (02392) 391100
