DOOR PANEL INSTALLATION
DOOR PANEL INSTALLATION
ssembling the EL500SE microprocessed circuit.
A
1
2
old the door panel on the embedding box.
H
74
73
The EL500SE circuit is to be assembled on the top of the
embedding box. Insert the circuit in the top flanges of
the embedding box (1). Push-in the circuit in the
bottom flanges (2) by pressing the pcb board.
Select a direction to open the door panel; this selection should ease
the door panel wiring. The opening direction will be settled
through the hinges position, that must be passed through the
header clips as shown. For example, if the hinges are placed on
both clips of the lower header, the door panel will open
downwards; if they are placed on the right clips of both headers,
the door panel will open to left.
To hold the door panel on the embedding box,
insert the hinges in the embedding box lockers
as shown.
Link the sound module with the EL500SE
microprocessed circuit by using the
supplied flat cable.
ush buttons wiring.
P
To the 2nd push button (code 1) (only two ways kits).
To the 1st push button (code 106).
To the push buttons common terminal.
Plug the push buttons connection cable to the CN6 connector
of the EL500SE microprocessor circuit, this cable has 10
conductors (P1 to P8, B and CP) for the connection of push
buttons
The CP terminal must be connected to the push buttons
common terminal.
Link the push buttons inputs (P1 and P8) to the push buttons, as
shown in the example.
CN6
CP
P8
B
P7
P1
P6
P2
P5
P3
P4
Top view
CP: Black
B:
Red
P1:
Green
P2:
Orange
P3:
Blue
P4:
Violet
P5:
Yellow
P6:
White
P7:
Brown
P8:
Grey
Colours codes
EL500SE
Description CN6 connector
Push button 1.
Push button 2, (only two ways kits).
CP
P8
B
P7
P1
P6
P2
P5
P3
P4
IMPORTANT NOTICE:
Right push button must be connected to P8 terminal.
EL500SE description CN6 connector
