90
89
.
F
unction push buttons
TELEPHONE DESCRIPTION
ix the telephone to the wall
F
.
It is necessary to open the telephone for wiring and fixing
purposes To open the telephone, insert a plain screwdriver
into the slots and gently lever as shown in the drawing
.
.
P
. C
.
.
ass the installation wires through the corresponding hole and connect
them as shown on the installation diagrams
lose the telephone as
shown on the picture Once the telephone is closed, connect the
handset using the telephone cord and put it on the cradle
Avoid placing the telephone near sources of heat, in dusty
locations or smoky environments The telephone can be
fixed using an electrical embedding box or directly on the
wall, as shown on the picture If the telephone will be
installed directly over the wall, drill two holes of Ø6mm on
the specified positions, using 6mm wall plugs and Ø3.5 x
25mm screws
.
.
.
TELEPHONE INSTALLATION
If the handset is on the craddle sends a panic call to the porter's
exchanges that have enabled the reception of this type of call. If not,
allows to call to the master porter's exchange. During call reception
and communication progresses allows the lock release activation.
Auxiliary function push button
, depending on setting in the SW1 dip
switch will realize one of the following functions: Autoswitch-on, "PA"
output, call to a slave porter's exchange and intercommunication.
escription of configuration dip switch.
D
escription of programming push button.
D
Factory default
"Autoswitch-on" mode: switches 1 and 2 to ON.
With the handset off the cradle, allows to stablish audio communication with the
door panel that has been configured with the autoswitch-on function. This
function is disabled if a communication is already established.
"PA" output mode: switches 1to ON and 2 to OFF:
Regardless of the handset's position, it activates the "PA" telephone output.
"C
" mode: switches 1 to OFF and 2 to ON.
With the handset off the cradle, allows to call to a porter's exchange that it is
configurated as slave.
all to a slave porter's exchange
"
" mode: switches 1 and 2 to OFF.
With the handset off the cradle, allows to make an intercom call between two units
of the same apartment.
Intercommunication
The P3 programm push button is located in the top part left of the circuit,it is
accessed by opening the telephone. Allows to telephone enter in programming
mode with the door panel, (see programming process on page 91).
IMPORTANT:
Select
before programming the telephone.
the auxiliary function push button mode
The SW1 configuration dip switch is located in the top part left of the circuit,it is
accessed by opening the telephone and allow the next operation modes for the
auxiliary function push button:
P3
SW1
1
2
1
2
1
2
1
2
1
2
P3
1
2
